Stretch-blow moulders are the heartbeat of every PET production line. A two-hour blower stoppage on a 24,000 BPH line can cost a beverage manufacturer USD 8,000–15,000 in lost output, plus scrapped preforms and spoiled syrup. Our blower specialists keep that from happening — and when it does, we get you running again the same shift.

Every blower brand. Every generation.

We're brand-agnostic by design, because real plants run mixed fleets. Our field engineers carry installation experience and maintenance certifications across:

  • blow-moulding equipment — rotary blow-moulding system Universal (all generations), blow-moulding equipment high-output system, blow-moulding equipment high-output blower, integrated dry-preform system FMa
  • beverage-line equipment — PET production rotary blower Series III, IV, and V
  • filling and packaging equipment — rotary blow-moulding system 3, rotary blow-moulding system 3 Speed, rotary blow-moulding system AseptBloc
  • PET processing equipment — linear blow-moulding system 3, linear blow-moulding system 4, XTRA series, ECS preform systems
  • packaging equipment — SR series rotary blowers, integrated blow-fill-cap systems
  • bottling and closure equipment — SBF and HBF rotary stretch-blow moulders
  • injection blow-moulding equipment Technical Laboratory — SBIII-100LL-CSP and DPW one-step injection-stretch blow systems
  • stretch blow-moulding equipment ASB — PF Series, HSB Series, double blow systems

What we deliver — start to finish

Greenfield installation & commissioning

From foundation drawings and utility tie-ins to full mechanical and electrical integration, FAT/SAT, calibration, and operator handover. We work to OEM protocols so your warranty stays intact and your line OEE hits design spec from day one.

Preventive maintenance (PM) programmes

Scheduled servicing on the equipment-compatible interval — heating oven inspection and calibration, stretching system overhaul, preform-feed alignment, mould-cooling circuit checks, and wear-parts replacement. Documented PM packs go into your CMMS so audit-readiness is automatic.

Mould changeover & format change support

Format changes are where line speed often dies. We deliver fast, repeatable mould-change procedures plus operator training so your team can switch bottle formats without specialist intervention every time.

Heating-oven tuning & energy audits

Roughly 50–60% of a PET blower's energy bill is in the heating ovens. We tune lamp positioning, reflector alignment, and preform conditioning to drop kWh-per-bottle. Typical audit-and-tune savings range from 8% to 18% on oven energy.

Compressor & chiller integration

A blower starves without clean, dry, high-pressure air and consistent chilled water. We size, install, and service HP compressors (up to 40 bar), refrigeration dryers, industrial filtration air filtration trains, and process chillers as part of the blower scope — no finger-pointing between contractors.

Why plant managers in the GCC choose BMM for blowers

  • Same-shift breakdown response. Engineers based in Doha, Dubai, Riyadh, and Mumbai — typical on-site arrival inside 8 hours regionally, faster within country.
  • genuine replacement parts. No grey-market substitutions. Stretching rods, stretch cylinders, preform grippers, oven lamps, and wear parts sourced directly from OEM channels.
  • Multi-brand expertise from one provider. Most plants run mixed fleets. Standardising on one service partner cuts coordination overhead and gives you a single SLA.
  • Documented work, every visit. Service reports, parts-used logs, and recommendation notes — emailed within 24 hours of close-out.

Coverage

Engineers mobilised across Qatar, UAE (Dubai, Abu Dhabi, Sharjah), Saudi Arabia (Riyadh, Jeddah, Dammam), Oman, Kuwait, Bahrain, and pan-India. Emergency call-outs accepted 24/7.